Installation points of high temperature solenoid valve

The working principle of the high temperature solenoid valve: After the electromagnet is energized, the connecting rod is lifted, and as the shaft starts to rotate, this movement acts on the pilot valve to open the main valve; after the power is off, the pilot valve is closed under the action of the armature's own weight and the return spring , After the pilot valve is closed, the main valve is closed by the pressure difference. Magnetic turning column level gauge

The main points of installation of high temperature solenoid valve are as follows:

1. When installing, the solenoid valve coil should be upward and keep the vertical position. The arrow or mark on the solenoid valve should be consistent with the flow direction of the pipeline, and it should not be installed in a place with splashing or water leakage

2. The working medium of the solenoid valve should be clean and free of particulate impurities. The dirt and filters on the surface of the solenoid valve internals should be cleaned regularly.

3. When the solenoid valve fails, in order to isolate the solenoid valve in time and ensure the normal operation of the system, install a bypass device

4. In the pipeline system, the diameter of the solenoid valve installed on the branch should be smaller than that of the main pipeline valve.

5. The pipeline must be cleaned before installing the solenoid valve. It is recommended to install a filter in front of the valve and install a trap in the steam pipeline.

6. The valve cannot be installed in the low recess of the pipeline, so as not to hinder the operation due to the precipitation of steam, condensate, impurities, etc. The electromagnetic valve

7. It can not be used in explosive hazardous situations.

8. When the rigidity of the pipeline is insufficient, it is recommended to fix the pipeline in front of the valve with a bracket to avoid vibration when the solenoid valve is working.

9. Before installation, pay attention to the product label, carefully read the instruction manual, and judge whether the product meets the conditions of use.

10. Pressure gauges should be installed on the pipes before and after the solenoid valve to observe the pipe pressure.

 This article is original by gas solenoid valve, please indicate http://www.sungofluid.com/